A real fab shop, not a sub contract chain.
Everything is made here. Folding, welding, drilling, deburring, then straight onto the line for coating. No couriers between three businesses, no waiting on a third party, no surprises when a flashing turns up the wrong way around.
Aluminium flashings,
made on site.
Standard flashings and flats from 0.9 mm to 2.0 mm, in lengths up to 6 metres. Heavier 3 mm flashings up to 3.6 metres. Anodised sheet at 1.2 mm in 3.6 metre runs. Custom welded saddle flashings, diverter flashings, and profile cut end caps and fillings, made to your specifications and finished to colour in the same shop.
- Standard flashing
- 0.9 mm, 1.2 mm, 1.6 mm, 2.0 mm
- Heavy flashing
- 3.0 mm, up to 3.6 m length
- Stock plate
- Up to 5 mm
- Anodised sheet
- 1.2 mm, 3.6 m
- Custom welded
- Saddles, diverters, end caps
Aluminium downpipes,
any colour, fast.
Round in 80 mm and 100 mm, rectangular at 100 by 50 mm, with bends and brackets to match. Because we coat in house, we can turn a colour around a lot faster than ordering coloured stock from a national supplier and waiting on the run.
- Round
- 80 mm, 100 mm
- Rectangular
- 100 mm by 50 mm
- Components
- Bends, brackets, junctions
- Finish
- Mill, or any powder colour
Coloured downpipes ordered from a roll often come back the wrong shade, the wrong length, or six weeks late. We don’t. We bend it, we cut it, we coat it, here.
Angles, flats, RHS, off the rack.
A wall of aluminium extrusion in stock, ready to cut to length. Angles, flat bar, rectangular hollow section, up to six metre runs. Mill finished, or coated in your colour before it leaves the shop.
- Angles
- Equal and unequal
- Flat bar
- Up to 6 m
- Rectangular hollow section
- Up to 6 m
- Cut to length
- Yes, on request
- Coated
- Mill or powder